Advertisement
1
(1) Channel Select 1~4: These momentary push-buttons select which of the four input signals is sent to the output. To select a desired
input, press the corresponding push-button (see Remote Control on pages 4 & 5). The adjacent LED indicator will light, indicating the
selection. Only one input can be selected at a time. If power is lost or turned off, Channel Select reverts to Input 1 when power returns.
The VSX41 may be used as a "router", with a single input signal being switched to one of four outputs (see Applications on page 9). The
VSX41 may be used with either video or audio signals. From the factory, Inputs 1~4 have 'back-termination' of 3.9k ohms, which is
appropriate for most applications. However, internal jumper straps allow selection of 75 ohm 'back-termination', which is required only for
specific video applications (see Options on page 6).
(2) Error: This red LED indicates when unusable information is received via remote control (see Remote Control on page 4 & 5). Errors
in transmission/reception of remote control commands, or improperly connected controls, will cause the Error indicator to light.
(3) IR: This red LED indicates when information is received via remote control. If the IR and Error indicators light simultaneously, this may
be an indication of improper installation. Check the location and wiring of all remote controls.
(4) Internal Infrared Receiver: This green infrared detector receives commands from optional hand-held Infrared Transmitters (see
Remote Control on page 4). A transmitter will work up to 30 feet from the receiver. For best results, there should be an unobstructed line-
of-sight from the transmitter to receiver. When infrared commands are received, the IR indicator will light. If the IR and Error indicators
light simultaneously, this may be an indication of improper installation. The Internal Infrared Receiver should not be located in direct
sunlight, or pointed directly at fluorescent lighting. An internal jumper strap is provided to allow the user to bypass the Internal Infrared
Receiver (see Options on page 6).
(5) Power: When the Power switch is turned on, the red "On" LED will light and Channel Select will revert to Input 1.
FRONT PANEL
channel select
2
3
4
(1)
2
ADVANTAGE VSX41
Video Switcher
Error
IR
on
(2) (3) (4)
(5)
Advertisement
