Toyota 2003 4Runner navigation system Operating Manual page 143

(b) Presetting a station
1. Tune in the desired station.
2. Touch one of the station selector switches (1–6) and hold it until a beep is heard. This sets the station to the switch
and the frequency appears on the switch
Each radio mode (AM, FM1 or FM2) can
store up to 6 stations. To change the
preset station to a different one, follow
the same procedure.
The preset station memory is cancelled
when the power source is interrupted by
battery disconnection or a blown fuse.
4Runner_Navi_U (L/O 0208)
(c) Selecting a station
Tune in the desired station using one of
the following methods.
Preset tuning: Touch the switch (1–6) for
the station you want. The switch is high-
lighted in green and the station frequency
appears on the screen.
Seek tuning: Push the "SEEK/TRACK"
button on either side. The radio will begin
seeking up or down for a station of the
nearest frequency and will stop on recep-
tion. Each time you push the button, the
stations will be searched out one after
another.
2003 MY 4Runner Navigation from Aug. '02 Prod. (OM35799U)
To scan all the frequencies: Touch the
"SCAN" switch on the screen or push the
"SCAN" button briefly. "SCAN" appears on
the screen. The radio will find the next
station and stay there for a few seconds,
and then scan again. To select a station,
touch the "SCAN" switch or push the
"SCAN" button again.
135