Parts And Tools - Toyota Land Cruiser 2000 Operating Manual

NOTICE
z Remember that battery and ignition
cables carry high currents or volt-
ages. Be careful of accidentally
causing a short circuit.
z Add only demineralized or distilled
water to fill the radiator. And if you
spill some of the coolant, be sure
to wash it off with water to prevent
it from damaging the parts or paint.
z Do not allow dirt or anything else
to fall through the plug holes.
z Do not pry the outer electrode of a
spark plug against the center elec-
trode.
z Use only spark plugs of the speci-
fied type. Using other types will
cause engine damage, loss of per-
formance or radio noise.
z Do not reuse iridium- tipped spark
plugs by cleaning or regapping.
z Do not overfill automatic transmis-
sion fluid, transfer oil and power
steering fluid, or the transmission,
transfer and power steering could
be damaged.
L/C 100_U
z Do not drive with the air cleaner
filter removed, or excessive engine
wear could result. Also backfiring
could cause a fire in the engine
compartment.
z Be careful not to scratch the glass
surface with the wiper frame.
z When
closing the engine
check to see that you have not for-
gotten any tools, rags, etc.
2000 L/C 100 (OM60866U)

Parts and tools

Here is a list of parts and tools you will
need on performing do- it- yourself mainte-
nance. Remember all Toyota parts are de-
signed in metric sizes, so your tools must
be metric.
Checking the engine oil level
Parts (if level is low):
D
Engine oil API
hood,
"Energy- Conserving"
ILSAC multigrade
proper for your climate
Tools:
D
Rag or paper towel
D
Funnel (only for adding oil)
Checking the engine coolant level
Parts (if level is low):
D
"TOYOTA Long Life Coolant" or equiva-
lent
See Section 7- 2 for details about cool-
ant type selection.
D
Demineralized or distilled water
Tools:
D
Funnel (only for adding coolant)
grade SJ,
multigrade or
having viscosity
229