Toyota Corolla 2002 Operating Manual page 114

1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station (see "TUNE" button).
Push and hold down the button until you
hear a beep—this will set the station to
the button. The button number will appear
on the display.
To tune in to a preset station: Push the
button for the station you want. The but-
ton number and station frequency will ap-
pear on the display.
These systems can store one AM and one
FM station for each button. The preset
station memory will be canceled out if the
power source is interrupted (battery dis-
connected or fuse blown).
(Eject button)
Push this button to eject a cassette.
AM·FM
Push "AM·FM" to switch between the AM
and FM bands. "AM" or "FM" will appear
on the display.
If the audio system is off, you can turn
on the radio by pushing "AM·FM". Also,
push "AM·FM" to switch from cassette op-
eration to radio operation.
114
'02 Corolla U (L/O 0105)
BAL (Balance)
Move the "BAL" ring around "TONE" to
adjust the balance between the right and
left speakers.
FF (Fast forward)
Push the "FF" to fast forward a cassette
tape.
To stop the tape while it is fast forward-
ing, lightly push the "REW".
If a tape fast forwards completely, the
cassette player will play the other side of
the tape, using the auto–reverse feature.
PROG (Program)
Push "PROG" to select the other side of
a cassette tape.
Auto–reverse feature: After the cassette
player reaches the end of a tape side, it
automatically reverses and begins to play
the other side. This is true whether the
cassette was playing or fast forwarding.
REW (Rewind)
Push the "REW" to rewind to a tape.
To stop the tape while it is rewinding,
lightly push the "FF".
If a tape side rewinds completely, the cas-
sette player will stop and then play that
same side.
2002 Corolla_U (OM12743U)
ST (Stereo reception) display
Your radio automatically changes to stereo
reception when a stereo broadcast is re-
ceived. "ST" appears on the display. If the
signal becomes weak, the radio reduces
the amount of channel separation to prev-
ent the weak signal from creating noise.
If the signal becomes extremely weak, the
radio switches from stereo to mono recep-
tion.
TAPE
Push "TAPE" to switch from radio opera-
tion to cassette operation. If the audio
system is off, you can turn on the cas-
sette player by pushing "TAPE". In both
cases, a cassette must already be loaded
in the player.
TONE
Turn the "TONE" knob to adjust the tone.