Table of Contents
Advertisement
Fig. C
B
G
L
UNPACKING AND CHECKING
CONTENTS (Fig. C)
This Bench Grinder will require a minimal amount of
assembly.
1. Remove parts from all of the cartons and lay them
on a clean work surface.
2. Remove any protective materials and coatings from
all of the parts and the bench grinder. The protec-
tive coatings can be removed by spraying WD-40
on them and wiping it off with a soft cloth. This may
need to be redone several times before all of the
protective coatings are removed completely.
CAUTION: DO NOT use acetone, gasoline or
lacquer thinner to remove any protective coatings.
3. Compare the items to Figure C; verify that all items
are accounted for before discarding the shipping
box. If there are any missing parts, call Customer
Helpline 1-800-266-9079.
WARNING
If any parts are missing, do not attempt to plug in the
power cord and turn "ON" the Bench Grinder. The
Bench Grinder can only be turned "ON" after all the
parts have been obtained and installed correctly.
CARTON CONTENTS
C
H
I
M
D
E
O
N
The following items are to be provided in the shipping
box:
A. Grinder (not shown)
B. Eyeshield assembly, left
C. Eyeshield assembly, right
D. Wheel dresser
E. Spark arrestor, left
F. Spark arrestor, right
G. Tool rest support, left
H. Tool rest support, right
I.
Carriage bolt M6 x 12 (2)
J. Pan head screws w/ washers M5 x 10 (4)
K. Flat washer M6 (4)
L. Tool rest, left
M. Tool rest, right
N. Eyeshield knob (2)
O. Tool rest knob (2)
7
F
J
K
Advertisement
Table of Contents
