Rival Deep Fryer Owner's Manual page 6

HOW TO CLEAN YOUR ELECTRIC DEEP FRYER
WARNING:Always turn control to "OFF" then disconnect plug from wall
outlet BEFORE disconnecting BREAK-AWAY CORD.
CAUTION:
• Do not immerse cord sets in water or any liquids.
• Do not attempt to defeat the detachable magnetic Break-away cord
system by trying to permanently attach cord set to product.
• Do not stick pins or other sharp objects in holes on magnetic cord
set.
• Do not use any type of steel wool to clean magnetic contacts.
1. Unplug from outlet and allow unit to cool completely.
2. Remove Break-away magnetic cord from the fryer.
3. Clean the outside of the Deep Fryer and lid with a damp cloth.
CAUTION: Do not use abrasive pads or alcohol.
4. Remove Frying Basket. Wash the Frying Basket in the dishwasher or
with hot soapy water. Rinse and towel dry carefully.
5. Lift Control Panel Assembly up from backside of fryer.
CAUTION: Be sure you have allowed enough time, after using, for Control
Panel Assembly to cool down completely.
• Carefully lift Oil Reservoir out by holding the rim of the bowl. Store in
an airtight container. See Tips for Oil Use and Storage on page 13.
6. The Basket, Main Lid (remove Filters), and Oil Reservoir are
dishwasher safe. Dry all parts thoroughly after cleaning.
7. The Control Panel Assembly should never be immersed into water or
other liquids. Gently clean the outer surface of the Control Panel
Assembly with a damp cloth containing mild soap solution or plain
water.
8. Ensure that both the lid and the Oil Reservoir are completely dry
after washing and before use.
-10-
HOW TO CLEAN YOUR ELECTRIC DEEP FRYER (CONT)
9. After cleaning, reassemble Control Panel
Assembly onto the Stainless Steel Exterior
(See figure 3). The Control Panel Assembly
must be attached properly to the back of the
Stainless Steel Exterior or the appliance will
not operate.
10. For storage, Folding Basket Handle can be
folded down to fit inside the Oil Reservoir.
CLEANING REPLACEMENT FILTERS
1. Open the Filter Cover.
2. White Cotton Grease Filter may be washed in hot soapy water. Rinse
and allow to air dry.
3. Clean the inside of the cover with a damp soapy sponge. Rinse and
dry thoroughly.
4. Insert Charcoal Odor Filter on the bottom of Removable Lid, followed
by a clean Grease Filter, then replace the Filter Cover.
NOTE: Replacement filters can be purchased at many retailer locations or
at www.rivalproducts.com.
Figure 3
-11-