Rival Deep Fryer Owner's Manual page 5

HOW TO USE THE DIGITAL ELECTRIC CONTROL PANEL
1. Plug the Power Cord into outlet.
2. The LCD displays 265°F. Press "TEMP+" and "TEMP-" button to set the
desired temperature."TIME+" and "TIME-" buttons will not operate
until the temperature reaches the preset temperature.
3. Press Start/Stop to start.The LCD display shows the set temperature
with a small arrow on the top of the LCD showing "Preheat". During
the preheat process, the heating element is energized and the LCD
small arrow under the "Preheat" marking will flash to show the
progress.You can press "Start/Stop" to stop
pre-heating, at this moment and the LCD
will show the set temperature.
4. When the oil temperature reaches the set
temperature, the unit will give an audible
signal and the pre-set temperature on the
LCD display will also flash continuously.The
Preheat Light will extinguish, indicating that
the oil is at the preset temperature.
5. Press "TIME+" and "TIME-" to stop the audible signal and to set
cooking time (from 1 min to 30 mins.). Put the basket with food into
the oil and start frying.The LCD display shows the remaining time for
frying food and the small arrow on the top of LCD display, displays
"Frying". Five seconds after setting frying time, the unit starts frying
(or you can press "Start/Stop" button to start frying). During the frying
mode, the small arrow under the "frying" will flash.You can press
"TEMP+" or "TEMP-" to check the temperature you set but you cannot
adjust the temperature. 3 seconds after you have checked the
temperature, the unit will return to the timing mode automatically.
ready
light
on/off
temp
time
-8-
HOW TO USE THE DIGITAL ELECTRIC CONTROL PANEL
You can press "TIME+" to prolong the frying time and the LCD display
shows the remaining frying time.You can press "Start/Stop" to stop
frying as well and the LCD display shows the temperature you set.
6. When frying is finished the unit will give an audible signal and the
LCD display will show 0:00 only.The heater is turned off
automatically at this moment.You can press "TIME+" and "TIME-" to
fry again within 10 minutes after the unit beeps.After frying, if you
press the temperature button, either Temp+ or Temp-, only the latest
set temperature will be shown.To set up or down the temperature for
next run, please reset the "Start/Stop" button again and follow step 2.
7. Press "Start/Stop" to reset another frying cycle. If you do not press
"Start/Stop" button, the unit will automatically reset back to your
latest frying temperature after 10 mins.The display will show the
latest temperature also.
NOTE: If you reset the temperature during the preheat process, as long
as the temperature is higher than the reset temperature, the unit will
beep and the reset temperature on the LCD display will also flash
continuously to indicate that food can be fried now, set time and
push Start.
-9-