Table of Contents
Advertisement
I. Optional Log Kit
Ceramic log #3-40-674099
Log Bracket Kit #1-00-774401
Remove the two bolts from the air manifold below the
glass opening. Install the log bracket using the same
two bolts. Place the log onto the bracket with the
smaller twigs pointing back toward the burn pot.
Please Note; The decorative log is fragile and must be
handled with care. The abrasive nature of pellet ash
may cause the log to deteriorate. Therefore, the log is
not covered under the appliance warranty.
J. Optional Trim Kit- #1-00-00775-*
The trim kit option includes a door frame and an ash
lip trim. To install the ash lip trim, simply slide it over
the ash lip from the front. You can secure it with a few
dabs of high temperature silicone, if desired. To install
the door trim, follow these steps.
•
Remove the door latch
by loosening the small
set-screw and tapping
out the roll pin.
•
Remove the door
by lifting it off of the
hinges. Lay it, face
down on a flat surface.
•
Locate and drill the
dimpled holes in each
corner of the door,
using the provided drill
bit.
•
Install the trim frame with
the threaded studs through
the holes in the door, and
secure it with the four nuts
provided in the kit.
* Trim finish suffix; 4=Gold,
7=Brushed Stainless, 8=Bright Nickel
22
Pellets or Corn/Pellet Mixture Only
K. Service Rail Kit- #1-00-774125
The Service Rail Kit is used to support the insert
body while it is pulled out of the mounting frame for
cleaning or service. Used only with a raised hearth
installation, it is easily adjustable to a height range
of 4" to 14". Assemble the rail kit using the provided
instructions. After removing the Ash Pan cover, the
rails attach to the mounting frame with four bolts.
There are even stop bolts on the rails to prevent
accidental roll-off.
Set-screw
Roll Pin
3-90-775
P35i Fireplace Insert
Two bolts on each side
secure the rail kit to the
mounting frame.
Save These Instructions
Advertisement
Table of Contents
