Input Panel Diagrams - SWR GOLIATH III Owner's Manual

TILT-BACK DESIGN
SWR's Megoliath, Goliath Senior, Big Bertha and Henry The 8x8 feature a tilt-back design for easy
transportation. To take advantage of this feature, firmly grasp the bar or handle (depending on the
model) found on the top rear surface of the enclosure. Carefully pull the top of the cabinet toward you
so that the enclosure balances on its heavy-duty caster wheels. When a comfortable balance is
achieved, push forward in the direction you want to move the enclosure.
REMOVABLE CASTER WHEELS – GOLIATH III AND 12-STACK MODELS
The Goliath III and the 12-Stack are shipped with a set of four, heavy-duty, removable caster wheels. SWR
uses only closed shaft sockets so as to prevent air leaks or unwanted noise when the enclosure is in use.
To install the caster wheels on these speaker cabinets, carefully turn the enclosure upside down (or on its
side) so that the caster base/sockets are visible. Insert the shaft of each caster wheel into a socket on the
underside of the speaker cabinet. When all four wheels are firmly in place, return the cabinet to its upright
position and you're ready to roll. You can leave the casters in place during performance, but it's recom-
mended that they be removed prior to setting up your amplification system. This will allow your cabinet to
couple to the floor, which can be helpful in extending your system's bass response. Please note that the
ball bearing type caster wheels provided with your Goliath III or 12-Stack cabinet may require periodic
replacement depending on usage and care. Replacement caster wheels can be purchased from the SWR
Service Department.

INPUT PANEL DIAGRAMS

INPUT PANEL DIAGRAMS
All models (except Big Ben, 12-Pack, 12-Stack and Megoliath)
Tweeter Attenuator
Control
1/4" Input 1/4" Output Speakon Input Speakon Output
BASS SPEAKER ENCLOSURES OWNER'S MANUAL • 3