Aqua Sensor; Start Programme - Bosch Dishwasher Instructions For Use Manual

en

Aqua sensor *

* on applicable models
The Aqua sensor is an optical measuring
device which measures the turbidity of the
rinsing water. A light barrier can detect
dissolved food remnants in the water, e.g.
egg, fat and oats.
The Aqua sensor is used according to
the programme. When the Aqua sensor
is active, "clean" rinsing water may be
transferred into the next rinsing bath
and/or the temperature adjusted. If the
turbidity is greater, the water is drained
and is replaced with fresh water. In this
way the water consumption is reduced by
approx. 4 litres for utensils which are "less"
dirty.
Optical indicator during
operation *
* With some models
During the rinse programme a light point
appears on the floor below the device's
door. Only open the dishwasher door
when the light point has disappeared.
In the case of built-in dishwashers with
flush front the light point will not be visible.
26

Start programme

Before starting check again whether the
spray arms can move freely.
Press the button "Start"
Menu.
The message "Close the door" will be
displayed, alternating with a display of
the expected programme time. This time
is only approximate. The running time
indicated at the start of the set programme
will probably be required. During the
programme run the remaining time will be
adjusted according to the water supply
temperature and the amount and soil level
of the dishes.
If you have chosen a time for the
programme start the message "Close the
door" will appear when the programme is
started, alternating with the pre-selected
time.
Close the door.
The programme or the pre-selected time
respectively will run.
The programme and other settings can still
be changed as long as the door is still
open after pressing the button "Start"
By pressing the button M/OK
"Return", return to the Main Menu where
you can change the settings. Finally start
the programme again.
When the door is closed after the start and
the programme has already started, you
will have to interrupt the programme in
order to change any settings (see "Cancel
Programme").
in the Main
4
.
4
2