Yamaha P7000S Owner's Manual page 4

Connector pin assignments
XLR-type connectors are wired as follows
●
Pin 1: ground; Pin 2: hot (+); Pin 3: cold (–).
Always turn the power off when the amplifier is not in use.
Illustrations in this manual are for explanatory purposes only, and may not match the actual appearance of the product during operation.
Company names and product names used in this Owner's Manual are trademarks or registered trademarks of their respective owners.
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not
expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.
2. IMPORTANT:
When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s
supplied with this product MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authori-
zation to use this product in the USA.
* This applies only to products (P7000S, P5000S) distributed by YAMAHA CORPORATION OF AMERICA.
4
— For correct operation —
FCC INFORMATION (U.S.A.)
Interference from Cell Phones
Use of a mobile phone near this unit may induce noise. If noise
●
occurs, move the phone further from the unit.