Advertisement
Attaching the Legs
Step 1.
Lower leg sections have a wire in one end. Push a
plastic end cap onto opposite end, without the wire, as
shown. Repeat for the other three lower leg sections.
Wire
Lower leg
Step 2.
With a slight twisting motion, push wire end of a lower
leg into completely open end of upper leg (other end
is knob-shaped). Repeat for other three lower legs.
Knob
Dimple
Upper leg
Step 3.
Push knob shaped end of a
leg assembly onto plastic peg
inside end of motor housing as
shown. Push down until leg
snaps in place. Repeat for
other three legs.
CHECK that all legs are
securely attached to the
motor housing by pulling
firmly on them.
Step 4.
Open the swing legs
completely. If necessary, turn
legs to line up the dimples on
the legs with the plastic leg
braces. Snap leg braces onto
outside of legs. The plastic
pegs inside the ends of the
braces will fit into the dimples
on the legs.
It may be necessary to spread
the legs as shown.
Do not use
the swing without the leg
braces.
To close legs for storage, first
unsnap leg braces. Then pull
the tabs under the motor
outward as shown, and move
the legs inward.
To remove legs completely,
first move legs inward, then
pull out with a twisting motion.
135-1-99 IS2131
5
Attaching the Seat
Step 1.
Slide hanger tubes into both
armrests of seat.
If your model has side-facing
No wire
metal buttons instead of for-
ward-facing buttons at top of
hanger tubes, the side-facing
End cap
buttons must face toward the
seat as shown.
Line up holes in both armrests
with holes in the hanger tubes.
Put a screw through the holes,
with head of screw on inside
Wire
of the seat. Fasten screws with
an acorn nut, and tighten
securely with enclosed wrench.
Lower leg
must overlap armrests, as
shown enlarged at right.
Knob
Step 2.
PUSH
With seat facing front of swing,
push ends of both hanger tubes
into the brackets as shown.
When the metal buttons pop out
into the bracket holes, the tubes
are locked.
Peg
CHECK that the hanger tubes
are secure in brackets by
pulling firmly on them.
To remove hanger tubes from
brackets, push metal buttons in
Dimple
and pull hanger tubes out.
Step 3.
Slide the seat wire through the
seat back loops.
Push
Step 4.
Insert the end of the seat wire
through the hanger tubes as
Push
shown. Then screw plastic nuts
on both ends of the seat wire
and tighten securely with the
enclosed wrench.
Pull
tabs
swing if the seat wire is not
securely attached. If seat can
recline backwards between
the hanger tubes, check the
Move legs
wire assembly.
metal buttons
Acorn nut
on outside
of seat
The seat back
Do not use
6
Side-facing
A
face toward
S
seat
Th
be
sh
S
Op
sid
S
Th
as
su
co
be
th
A
Yo
Fo
V
(o
S
Sl
se
S
Pu
be
co
If
op
th
to
Advertisement
