Accessing The Basic Settings; Care And Cleaning; Hob; Hob Frame - Bosch PIF6..T1 Series Instruction Manual

Accessing the basic settings

The hob must be turned off.
Switch on the hob.
1.
Within the following 10 seconds, press and hold the
2.
symbol for 4 seconds.
appears on the left of the screen and
™‚

Care and cleaning

The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition

Hob

Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cold enough
before attempting to clean it.
Only use cleaning products specifically designed for glass-
ceramic hobs. Follow the instructions provided on the
packaging.
Do not use:
Abrasive products
■
heavy-duty cleaners, like oven sprays and stain removers
■
Pads that may scratch
■
High-pressure or steam cleaners
■
Glass scraper
Remove dried-on food remains using a glass scraper.

Fixing malfunctions

Malfunctions are generally caused by minor faults. Before
contacting the Technical Assistance Service, make sure you
have read the following recommendations and warnings.
Indicator Malfunction
none The electric power supply has been inter-
rupted.
The appliance has not been correctly con-
nected following the connection diagram.
Electronic system malfunction.
* If the warning persists call the Technical Assistance Service.
Do not place hot pans on the control panel.
10
Press the
3.
required function appears.
Then select the required setting using the + and - symbols.
4.
@
Press the
5.
seconds.
The settings have been saved.
on the right .
‹
Quit
To leave the basic settings, turn off the hob at the main switch.
Release the scraper safety catch
1.
Use the blade to clean the hob surface
2.
Do not attempt to clean the hob surface with the base of the
scraper. This could result in scratching.
ã=
The blade is extremely sharp. Risk of cuts. Protect the blade
when not in use. Replace the blade immediately when any
imperfections are found.
Care of the appliance
Apply an additive to protect and preserve the hob. Follow the
advice and warnings provided with the product.

Hob frame

In order to avoid damage to the hob frame, follow the
indications below:
Use only slightly soapy hot water
■
Do not use sharp or abrasive products
■
Do not use a glass scraper
■
Measure
Use other electrical appliances to check if there has been a power
cut.
Make sure that the appliance has been connected correctly.
If in the above checks, the malfunction is not resolved, contact the
Technical Assistance Service.
@ symbol several times until the indicator for the
symbol again and hold it for more than 4
@
Risk of injury!!