Page 1
Please read these instructions before using your FS/2 HUSKY FS/2 USER LEAFLET...
Page 2
The FS/2 leaves the factory fitted with non-rechargeable Alkaline batteries and is ready for use. Note: If you fit new rechargeable batteries instead, you must charge the FS/2 before use; please refer to BATTERIES. PgUp PgDn...
Page 3
(or functions) shown above the keys. 10 BACKLIGHT KEY: press to illuminate the screen for use in low light. You may need to press the same time (depending how your FS/2 is set up). 11 TYPING KEYS: type letters, or symbols and functions when used with S (SHIFT).
In low ambient light, press C to turn the backlight on. To turn it off, press C again. You may need to press at the same time (depending how your FS/2 is set up). The backlight turns off automatically after a short time, to conserve power.
However, if power does run low, a warning BATTERY LEVEL LOW will be displayed. (After a further period of use, your FS/2 will turn itself off and will not turn on again.) You should do one of the following: Return the FS/2 to your base or office.
Observe the instructions printed on the battery. Replace only with batteries approved by your FS/2 supplier. DO NOT FIT LITHIUM BATTERIES. ATTENTION: Dispose of or recycle used batteries according to the manufacturer’s instructions.
Page 7
CLEANING If the screen gets dirty or smeared, clean it with a clean cloth. If the FS/2 gets very dirty, it should be cleaned: Make sure that the battery cap is tight. If you have dropped it, check that the case and seals are intact.
(2) this device must accept any interference received, including interference that may cause undesired operation. If the FS/2 does cause harmful interference, turn it off and consult your dealer or technician for help. The FS/2 must only be used with approved peripherals and approved A.C.