BLUE SKY PRODESK SUB 8 ACTIVE SUBWOOFER Owner's Manual page 9

1. RIGHT/LEFT IN - These XLR inputs should be connected to the
right/left output of your console or digital workstation. The inputs
are electronically balanced. Do not connect more than one
source to these inputs. Refer to the wiring table below for wiring
custom cables and connectors.
2. RIGHT/LEFT OUT - This XLR output should be connected to the
right/ left input of the active satellite speaker. The outputs are
electronically balanced. These outputs are not bandwidth limited
and are designed to be used with the SAT 5 or other monitor
that has an 80Hz internal high pass filter network. Refer to the
wiring table in bullet point 1 for wiring custom cables and
connectors.
3. SUB IN - This XLR input should be connected to either the
subwoofer output of an external bass-management controller
or the daisy-chain output (SUB OUT) of another Blue Sky Active
Subwoofer. This input is electronically balanced. This input is full-
bandwidth (up to approximately 200Hz) and does not use a low
pass filter. Refer to the wiring table in bullet point 1 for wiring
custom cables and connectors.
4. SUB OUT - A Subwoofer output for connecting additional
subwoofers. This should be connected to the SUB IN of an
additional Blue Sky SUB 8.
5. SUB GAIN CONTROL & POWER LED - This knob controls the
input sensitivity of the subwoofer amplifier only. When set to the
reference position, a 100mv signal at the input equals 90dB of
output at one meter. Next to the knob is the power indicator LED.
6. FUNCTIONAL VOLUME CONTROL (FVC) RJ-11 Connector Jack
- This standard six conductor RJ-11 jack is used to connect the
subwoofer to the optional FVC. The remote control cable length
should not exceed 100 Feet. For more information on the FVC,
please turn to page 15 "The Functional Volume Control".
7. POWER SWITCH - This switch controls the power to the
subwoofer amplifier and all internal electronics.
8. FUSE - 2.0 Amp Slow Blow Fuse - Replace with same rating
and type. This fuse is for 120 VAC / 60Hz operation only. For
products purchased in countries outside North America, please
see the FUSE and POWER addendum included with this product.
9. IEC POWER TERMINAL - Connect to 120 Volt AC / 60Hz power
source, rated for 200 WATTS. Use the included IEC Power Cable.
blue sky ProDesk™ SAT 5 Active Satellite & SUB 8 Active Subwoofer
Owners Manual for 2.1 (Stereo) Applications Issue 1, rev 4
10. 1⁄4 X 20 INSERTS - Located on the bottom of the subwoofer
cabinet are four 1⁄4 X 20 inserts for spiked or rubber feet.
Page 9