Figure 16. Removing the hard disk drive (23-inch display)
6. Disconnect the signal cable and the power cable from the hard disk drive.
7. Flex the sides of the hard disk drive bracket properly to remove the hard disk drive out of the bracket.
8. To install the new hard disk drive into the bracket, flex the bracket and align pin
4
on the bracket with the corresponding holes in the hard disk drive.
Figure 17. Installing the hard disk drive into the bracket
9. Connect the signal cable and the power cable to the new hard disk drive.
10. To install the hard disk drive to the chassis, do one of the following:
• If your computer comes with the 20-inch display, align the two pins on the hard disk drive bracket
with the corresponding slots in the chassis and press the hard disk drive bracket downward until
it snaps into position.
1
, pin
2
, pin
3
, and pin
.
Chapter 9
Replacing FRUs
89