Using Your Freezer - Whirlpool EV200NXK User Manual

Using your freezer
Setting the Cold Control...
To start, turn control to the middle of the dial.
This setting will maintain zero zone temperatures
under normal operatrng conditions.
Adjusting Cold Control...
l
Turn control to higher number for colder
temperatures.
l
Turn to lower number for less cold temperatures.
Cooling Freezer First . . .
l
Allow freezer to cool 6 to 8 hours before filling
with frozen food.
l
Let it cool overnight before adding large
amount of unfrozen food.
Note: When freezer is first started the compressor
will run constantly until the cabinet is cooled. It
may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times
the freezer door is opened.
Afterthe cabinet is cooled the compressor will
turn on and off as needed to keep freezer at
proper temperature.
II
POWER SAVING CONTROL
I II
The Power Saving Control...
operates electric heaters. These heaters help
prevent moisture from forming on the outside of
the freezerwhen humidity is high.
l
Use the OFF setting when humidity is low to save
electricity.
l
Use ON only if moisture forms on outside of
freezer.
Exterilor Signal light...
auton 'atically warns of any unexpected power
failure.
If the ;ignal light is not glowing, immediately
check:
l
for po .ver interruption,
l
the p( wer cord; it may be disconnected from
the oc.?let,
l
the siclnal light; it may be burned out.
To repktce burned out signal light:
1. Unp!lJg power cord from outlet.
2. Remove base grille. See page 4.
3. Unpl Ag burned out light and replace with one
of solne wattage and size. Signal light can be
orde -ed from your WHIRLPOOL dealer, Part No.
5305: 34.
4. Rep1 Ice base grille. See page 4.
5. Plug oower cord Into outlet.
3