Whirlpool EV200NXK User Manual page 2

Before you plug if in
Before using your freezer, you are personally
responsible for making sure that it...
l
is installed and leveled on a floor that will
hold the weight, and in an area suitable for
its size and use.
l
is connected only to the right kind of outlet,
with the right electrical supply and
grounding.
l
is used only for jobs expected of home
freezers.
l
is not near an oven, radiator or other heat
source.
l
is prc Derly maintained.
l
is in c: dry sheltered place.
l
is use 3 in an area where the room tempera-
ture v~,ill not exceed 110 F (43.3 C].
l
is not
run
where there are explosive
fUmeS.
l
is not Iused by children or others who may not
unde stand how it should be used.
l
is not loaded with food before it has time to
get p.operly cold.
Install Properly...
Flush
against back wall
and cabinets
1. Check the strength of the floor. It should hold
the weight of fully loaded freezer.
2. Pick a safe place, indoors, away from in-
flammables such as gasoline.
3. Freezer may be installed flush against wall in
back and cabinets on each side.
level Freezer.. .
so that door will stay open at any position.
1. Remove base grille (see page 4 ).
Raise
Lower
Remove Sales labels...
Rem,)ve the Consumer Buy Guide label and
any in ide labels before using the freezer. Re-
move c:ny left over glue with rubbing alcohol.
I
Note: DO NOT REMOVE the Tech Sheet fas-
tene j behind the base grille.
I
Cleali It...
Clec.1 your freezer before using it. See clean-
ing insiluctions on page 5.
Plug it in...
Freeze
power 1:
Recommended Grounding Method
A 121 Volt, 60 Hz., AC only, 15 ampere fused
electric,al supply is required. It is recommended
that a separate circuit serving only this appli-
ance t le provided. The receptacle should not
be controlled by a wall switch or pull chain.
Do not use an extension cord.
See Individual electrical requirements and
grouncilng instruction sheet in your literature
packal:je.