Description - Echo SRM-2400SB Operator's Manual

99944200563

DESCRIPTION

Locate the safety decal(s) on your unit. Make sure the decal(s) is legible and that you understand and follow
the instructions on it. If a decal cannot be read, a new one can be ordered from your ECHO dealer. See
PARTS ORDERING instructions for specific information.
2
1.
FLEXIBLE DRIVE CABLE - Cable end fits into drive shaft coupler of Pro Attachment Series or Split Boom models.
Lubricate drive cable every 25 hours with high temperature automotive grease.
2. FENDER / WHEEL ASSEMBLY - Consists of pre-assembled wheels, wheel bracket, fender and rubber flap. For
best results, wheels should be adjusted for 13 mm (0.5 in.) ground clearance and are intended to provide
operational stability over uneven ground.
3. FENDER / RUBBER FLAP - Provides operator protection against thrown thatch, rocks and other debris. Always
insure that fender and flap are in place and in good condition before operating Pro Thatch Attachment.
4. LOWER DRIVE SHAFT ASSEMBLY - Included separately in the carton and must be assembled to the dethatcher
/ gear housing assembly. Contains flexible drive cable, outer shaft housing and safety decal.
5. DETHATCHER / GEAR HOUSING ASSEMBLY - Right and left reels pre-assembled to gear housing.
6. DETHATCHER REELS - Dethatcher reels have 22 tines each and are pre-assembled to the gear housing. Reels
must be installed properly to prevent side pull.
7. GRASS GUIDE - Attached to the dethatcher assembly / gear housing. The guide prevents tines from penetrating to
deeply into the ground, which can cause the dethatcher to bounce and give uneven thatch removal.
8.
TINES - Steel springs with 51 mm (2 in.) fingers. Tines are protected by a plastic cover to prevent thatch and dirt
buildup.
X7702093505
© 09/2013 ECHO Inc.
3
Shaft Label
1
5
6
7
8
DESCRIPTION
4
9