Gigabyte G1.ASSASSIN 2 User Manual page 25

Motherboard
Table of Contents

Advertisement

6) SATA3 0/1 (SATA 6Gb/s Connectors, Controlled by Intel X79 Chipset)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA3 0 and SATA3 1
connectors support RAID 0 and RAID 1. RAID 5 and RAID 10 can be implemented on the two connectors
with the SATA2 2/3/4/5 connector
on configuring a RAID array.
7) SATA2 2/3/4/5 (SATA 3Gb/s Connectors, Controlled by Intel X79 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device. The Intel X79 Chipset supports RAID 0, RAID 1,
RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring
BUG
a RAID array.
RT
DEBUG
PORT
(Note)
(Note)
A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives
are to be used, the total number of hard drives must be an even number.
A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does
not have to be an even number.)
A RAID 10 configuration requires four hard drives.
When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system performance
of the RAID set may vary depending on the devices being connected.
. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions
SATA3
7
1
7
1
SATA2
1
7
1
7
- 25 -
Pin No. Definition
1
GND
2
TXP
1
3
TXN
0
4
GND
5
RXN
6
RXP
7
GND
Pin No. Definition
1
GND
2
TXP
3
TXN
4
GND
5 3
5
RXN
4 2
6
RXP
7
GND
Please connect the L-shaped end of
the SATA cable to your SATA hard
drive.
Hardware Installation

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents