Table of Contents
Advertisement
23/24 ) FRONT_FAN/REAR_FAN (System Fan Connectors)
This connector allows you to link with the cooling fan on the system case to lower the system
temperature. These connectors are for system use only.
REAR_FAN
FRONT_FAN
25) BATTERY
If you want to erase CMOS...
1.Turn OFF the computer and unplug the power cord.
2.Remove the battery, wait for 30 second.
3.Re-install the battery.
4.Plug the power cord and turn ON the computer.
5.Or, you can use CLR_CMOS jumper to erase CMOS data
1
Pin No.
1
2
3
4
1
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer's instructions.
2 9
Connector Introduction
Definition
GND
12V
Sense
Control
Advertisement
Table of Contents
