Cmos Rtc & Isa Cfg Cmos Sram; Speaker Connector Installation; Power Led Connector Installation; Turbo Switch Connector Installation - Gigabyte GA-586TX2 User Manual

Pentium processor pci - isa bus mainboard

Table of Contents

Hardware Installation

3.7. CMOS RTC & ISA CFG CMOS SRAM

Built-in Real Time Clock (RTC) With 256B CMOS SRAM in PIIX4

There is always a speaker in AT system for sound purpose. The 4 - Pins

connector SPK is used to connect speaker. The speaker can work well in

both direction of connector when it is installed to the connector SPK on

mainboard.

There is a system power LED light on the panel of case. The power LED will

light on when system is powered-on. The connector should be installed to

PWR of mainboard in correct direction.

Function Reserved

The TURBO LED on panel can indicate the current speed status of system.

The TURBO LED connector should be installed to TD in correct direction.

The RESET switch on panel provides users with HARDWARE RESET

function which is almost the same as power-on/off. The system will do a cold

start after the RESET switch is pushed and released by user. The RESET

switch is a 2 PIN connector and should be installed to RST on mainboard.

3-10

Table of Contents

Show Quick Links

Chapters

Table of Contents