Table of Contents
Advertisement
the manufacturer.
M Dispose of used batteries according to the manufacturer's
instructions.
3.7. SPEAKER CONNECTOR INSTALLATION
There is always a speaker in AT system for sound purpose. The 4 - Pins
connector J5 is used to connect speaker.
The speaker can work well in both direction of connector when it is installed
to the connector J5 on mainboard.
3.8. HARDWARE RESET SWITCH CONNECTOR INSTALLATION
The RESET switch on panel provides users with HARDWARE RESET
function, which is almost the same as power-on/off.
The system will do a cold start after the RESET switch is pushed and
released by user. The RESET switch is a 2 PIN connector and should be
installed to J6 on mainboard.
3.9. POWER LED CONNECTOR INSTALLATION
There are system power LED lamps on the panel of case. The power LED
will light on when system is powered-on, which is connected to a 3 PIN
connector.
The connector should be connected to J7 of mainboard in correct direction.
3.10. IDE & ATAPI DEVICE INSTALLATION
There are two Enhance PCI IDE ports (CN9,10) on board, which following
ATAPI standard SPEC. Any one IDE port can connected to two ATAPI
devices (IDE Hard Disk, CD-ROM & Tape Driver), so total four ATAPI
Hardware Installation
3-7
Advertisement
Table of Contents
