Connecting The Printer To The Network, On; Setup For Netware; Netware Using Ndps Over Ip - Axis 540+ User Manual

Setup for NetWare

10
Setup for NetWare

NetWare Using NDPS over IP

Important:
If you want to print in NDPS, make sure that you have NDPS software installed on your NetWare
file server.
Note:
You can select to install the connected printers as Public or Controlled Access printers.
Having assigned an IP address to the AXIS 540/640 as described in, Assigning an IP
Address, on page 8, you are now ready to install the AXIS 540/640 for NDPS printing
over IP. Follow the instructions below:
1. Connect the AXIS 540/640to the NetWare network, if it is not already
connected. Refer to Connecting the printer to the Network, on page 7 for more
information.
2. Start the NetWare Administrator. Create an NDPS Manager object, if you do not
have one available.
3. Proceed to create the printer object as a Public or Controlled Access printer.
Please refer to the appropriate Novell documentation for instructions on creating
NDPS Manager objects and the printer objects.
Notes:
The HP-JETADMIN parameter of the AXIS 540/640 must be set to YES in order for the
communication between the AXIS 540/640 and the NDPS Gateway to be enabled.
NDPS requires that you run NetWare 4.11 or higher.
During the creation of the printer object, you must specify the IP address of the AXIS 540/640.
To print using TCP/IP, Axis print server firmware 6.1 or later is required. In order to print using
IPX/SPX, Axis print server firmware 5.51 or later is needed.
Enter LPT1 as your printer port, when prompted during the creation of the printer object.
AXIS 540/640 User's Guide