Navigating The Remote Control - Rinnai Avenger 25 Operation Manual

ABOUT YOUR PORTABLE CONVECTOR HEATER

NAVIGATING THE REMOTE CONTROL

ON button
39
Operates the heater.
OFF button
40
Stops the heater.
Up and Down buttons
41
Used to raise or lower the set temperature.
Infra red transmitter
42
Transmits signal to heater.
Battery
43
The remote control is powered by one CR2032 3V
battery. To replace the battery simply slide open the
battery cradle cover located on the back of the remote
control. When installing a new battery ensure that the
correct polarity (positive uppermost) is observed.
ONLY use the specified CR2032 3V battery for the remote control
The remote control will not function if the heater is in Timer mode.
IMPORTANT
If the heater is operating in Override mode, using the STANDBY button will cancel
any future timer operations, these will have to be reset manually.
Some fluorescent lights may interfere with the transmission of remote control
signals, in this case changing the position from which you are operating the remote
control may help.
Avoid leaving the remote control in direct sunlight and do not place the remote
control close to the louvres of the heater.
Avoid getting the remote control wet, or dropping it.
Rinnai Australia
39
ON
OFF
41
FRONT
3
42
REAR
40
OPEN
43
C R 2 0 3 2
Operation Manual