Locking Clip - Century PM-1589AB Instruction Manual

VEHICLE SEAT BELTS

Locking Clip

WARNING
Avoid serious injury or death:
• Failure to use locking clip where
required will result in car seat not
being securely held in place.
• Remove locking clip from seat belts
when not being used with car seat.
• DO NOT use locking clip as a vehicle
seat belt shortener.
You MUST use locking clip provided with
car seat with a vehicle seat belt that slides
freely through the latch plate or the lap belt
cannot be tightly secured.
1
Install car seat and tighten vehicle seat belt.
2
Hold seat belts together at latch plate (fig. a)
then unbuckle.
3
Slide locking clip on seat belts approximately
1/2 inch (1 cm) away from latch plate.
4
Re-buckle seat belt.
(continued)
5
Test installation to see if car seat is secure.
If not secure, additional belt tightening may be
required:
• Unbuckle vehicle seat belt.
• Hold belts together and remove locking
• Shorten length of lap belt portion slightly
• Re-attach locking clip.
• Buckle vehicle seat belt.
HINT: Press car seat further down into vehicle
seat cushion to help buckle vehicle seat belt.
(fig. b)
clip.
by pulling belt through latch plate.
1/2 inch (1 cm)
25