Table of Contents
Advertisement
OPERATIONS and ADJUSTMENTS
1
Harness Tie:
• To open: Press tab and pull apart (fig. a).
• To close: Snap halves together. Make
sure harness tie is locked by pulling out
on each half.
2
Buckle:
• To lock: Insert both tongues into buckle.
Pull up on tongues to be sure they are
locked.
• To unlock: Press red button and pull
tongues out of buckle.
3
Recline (fig. b):
• Recline: Slide tab on front of car seat to
allow recline foot to drop down.
• Upright: Slide and hold tab on front of
car seat while pushing recline foot up.
Release tab to lock foot.
4
Armrests (fig. c):
• Push in button on side of car seat and
rotate armrest up or down.
12
5
Tether Straps (fig. d):
• To tighten: Pull loose end of strap.
• To loosen: Lift adjuster.
6
Harness Straps (fig. e):
A To loosen: Lift adjuster bar and pull
harness straps from front of car seat to
desired length.
To tighten: Lift adjuster bar and pull
ends of harness straps down until all
slack is removed.
B Pull harness straps on front side to lock
adjuster bar.
C When adjusting harness straps, pull
harness straps through tongues in buckle
to remove all slack.
WARNING
To prevent serious injury or death:
End of each strap must be at least
2 inches (5 cm) below metal plate
(fig. h - page 15).
or
Advertisement
Table of Contents
