What To Do If; Remedying Small Malfunctions - AEG FAVORIT 50750 User Information

What to do if...

Remedying small malfunctions

If while the appliance is operating indicators on the control panel flash
or are lit up as described in the following table, please consult this to
find out how to remedy the fault.
After remedying the fault that is flashing in the first or second
rhythm in the programme progress display, press the button for the
dishwashing cycle that had already started. The cycle will continue.
If the fault is displayed again or if other faults are displayed, please
contact your local Service Force Centre and inform them of the fault
display.
Malfunction
The programme indicator for
the selected dishwashing cy-
cle is flashing,
the indicator for the end of
the dishwashing cycle is
flashing in sequence 1 short
light signal with approx. 3
second pause in-between:
(Problems with water inlet)
The programme indicator for
the selected dishwashing cy-
cle is flashing,
the indicator for the end of
the dishwashing cycle is
flashing in sequence 2 short
light signals one after anoth-
er.
24
Possible cause
The tap is blocked or furred
with lime-scale.
The tap is turned off.
The filter (where present) in
the threaded hose fitting on
the tap is blocked.
Filters in the base of the
washing compartment are
blocked.
Water inlet hose has not
been correctly positioned.
The sink spigot connection
is blocked.
Water drain hose has not
been correctly positioned.
Remedy
Clean tap.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Press the button for the
dishwashing cycle that
has started;
then cancel the dish-
washing cycle (see sec-
tion: Starting a
dishwashing cycle);
clean filters (see section:
Cleaning the filters).
Check hose installation.
Clean the sink spigot
outlet.
Check hose installation.