Front Panel Display; Adjusting The Brightness Of The Display; Examples Of Displays During Operation - Denon DBP-2010 Owner's Manual

ENGLISH
Introduction

Front Panel Display

1
* Brightness of the display can be adjusted. Refer to "Panel Display" in "Function Setup" on page 36.
1) Displays playback status icon. Refer to the table below.
2) Displays various kinds of information such as title number, elapsed time, repeat mode, etc.
Playback status icon
Disc SD Memory Card
(for AVCHD only)

Adjusting the Brightness of the Display

You can adjust the brightness of the display by the pressing [DIMMER] repeatedly. The brightness
changes as bright A dimmer A auto each time you press [DIMMER]. If you select auto, the display
gets dimmer during playback.
Note
• [DIMMER] is not available when the setup menu is displayed.
2
Mode
Playback is in progress
Stop mode
Pause mode
Fast forward mode
Fast reverse mode
Slow forward mode
Appears while repeat function is set

Examples of Displays during Operation

Display
Power on
Standby mode
Tray open
Tray is closing
Loading the disc
No disc inserted
This unit cannot read the disc or SD Memory Card inserted.
Stop mode
HDMI output mode (480i) is selected.
HDMI output mode (576i) is selected.
HDMI output mode (480p) is selected.
HDMI output mode (576p) is selected.
HDMI output mode (720p) is selected.
HDMI output mode (1080i) is selected.
HDMI output mode (1080p) is selected.
HDMI output mode (1080p24 frame) is selected.
HDMI output mode (Source Direct) is selected.
Pure direct mode is set to pure direct off.
Pure direct mode is set to video signal off.
Pure direct mode is set to front panel display off.
Pure direct mode is set to video signal and front panel display off.
Appears when the connected display device or other device does
not support HDCP.
Note
• When playing back the disc that contains more than 100 titles, display of the chapter and time
on the front panel display will be moved a few dots to the right.
9
ENGLISH
Introduction
Description