Replacing The Lamp; Closing The Door - Electrolux ERC33220W User Manual

Problem
The temperature in the
appliance is too warm.
The temperature in the
refrigeration is too warm.
The appliance does not
operate.
The lamp does not work.
Door interferes with ven-
tilation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.

Replacing the lamp

1. Disconnect the appliance from the pow-
er socket.
2. Fold the lamp cover backward by loos-
en the front edge.
3. Replace the bulb with one of the same
power and specifically designed for
household appliances (the maximum
power is shown on the light diffuser) and
with E14 socket type.
4. Reconnect the appliance.
Possible cause
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The food temperature is too
warm.
There is no cold air circulation in
the appliance.
Large quantities of food to be
cooled were put in at the same
time.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The appliance is not levelled.
The appliance is not levelled.
Set a colder temperature.
Refer to "Closing the door".
Let the food temperature de-
crease to room temperature be-
fore storage.
Make sure that there is cold air
circulation in the appliance.
Insert smaller quantities of food to
be cooled at the same time.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a another electrical ap-
pliance to the mains socket.
Check fuse. Contact a qualified
electrician.
Refer to "Replacing the lamp".
Refer to "Levelling".
Refer to "Levelling".

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
electrolux 9
Solution