Tascam IF-TAD Owner's Manual page 14

IF-TAD Interface
• On the TASCAM DA-98 and DA-88 DTRS recorders, the
CLOCK key is used to select between the different clock
sources available. If this is set to INT, the word clock is be
internally derived, or if a word clock is available at the BNC
WORD IN connector, the word clock is taken from there.
• On the TASCAM DA-38 DTRS recorder, the WORD
SYNC IN key is used to select between internal clocking
and an external word clock received at the WORD IN con-
nector.
• To set the TASCAM TM-D8000 digital mixing console
clock source, use the DIGITAL I/O ClOCK screen.
• To set the TASCAM TM-D1000 digital mixer clock source,
use the Master Clock Select sub-menu of the Option menu.
As well as the word clock selection, you should also
make sure that the audio input source and output con-
nectors for all units are set to the digital input receiving
data from the IF-TAD and the digital output transmit-
ting data to it.
On the TASCAM DTRS series of recorders, this is
done using the DIGITAL IN key.
2.2 Problems which may occur
Clock loss on the adat unit may be corrected by changing the pitch
on the ADAT recorder away from standard pitch, and then return-
ing it to standard pitch. This will force a re-locking of the clock.
Alternatively, you may have to turn off the adat recorder, wait for a
short while and then turn it on again.
14
– TASCAM IF-TAD
NOTE