Remote Control - Doro 916CR Manual

English

Remote Control

This machine can be remotely controlled using the keys of an ordinary tone dialling
telephone. Call up the answering machine and enter the remote code (see page 14)
while the outgoing message is playing. Once the code is accepted, several remote
control commands are available.
Remote Control
1. Call up the answering machine.
2. While the outgoing message is playing, enter the remote code. If the code is
accepted, you will hear two beeps.
3. Select a remote control command (within 10 seconds) from below.
4. When you have finished accessing the machine replace the handset.
Command
1#......................................... Play new messages
2#.. . ...................................... Play all messages
During playback:
3#. . ....................................... Erase single message during playback
4#. . ....................................... Repeat message/Skip to previous message
5#. . ....................................... Stop playback
6#. . ....................................... Skip to next message
After playback:
7#. . ....................................... Turn the answering machine either On or Off.
8#. . ....................................... Record a new outgoing message, to Stop
9#. . ....................................... Record a MEMO, to Stop recording press 5#.
0#. . ....................................... Room monitoring (active for 30 seconds press 0#
Room Monitoring
This remote access feature enables you to call your home and turn ON the
answering machine's microphone function, allowing you to monitor sounds in the
room where the answering machine is situated.
Please note!
If the machine doesn't respond correctly to the remote control commands, try
pressing the telephone buttons for a longer or shorter time. In normal cases, the
answering machine should react to tones approximately 0.5 – 1 seconds in length,
but longer tones may be necessary in certain telephone networks. If you do not enter
any remote control command, the answering machine will disconnect after a few
seconds.
If you listen to any incoming messages for more than 2 minutes and 40 seconds, you
will hear two beeps. Press any key to continue.

The Answering Machine
Function Function
recording press 5#.
to continue).
www.doro.com