Electrolux EK 5701 Instruction Booklet page 28

Replacement of grill burner nozzle
To replace the grill burner nozzle, follow this proce-
dure:
a) remove the screws (see fig.);
b) take the grill burner out;
c) with a socket spanner 7 unscrew and remove the
nozzle, situated in the top of the oven, and replace it
with the proper one (see Table at page 21);
d) undo the fixing screw of the metal ring of primary
air adjustment and adjust the relevant opening (see
diagram);
d) reassemble the burner following the same procedu-
re backwards.
Minimum level adjustment
of gas oven burner
After setting the oven on maximum temperature with
door closed for about 10 minutes, turn the knob on
minimum.
To reach the thermostat by-pass screw and adjust the
minimum level, act as follows:
– take out the knobs;
– remove the front panel;
– in case of conversion from natural gas to LPG, tightly
screw the by-pass screw of thermostat (see fig.);
– to convert from LPG to natural gas, unscrew the by-
pass screw, until a regular small flame is reached.
– finally check that turning quickly the tap from
maximum position to minimum position, the flame
does not go out;
– reassemble the front panel and the knobs.
The oven burner does not need any primary air
regulation.
28
Natural gas adjustment: full opening width
LPG adjustment: opening 10 mm wide
FO 1061