Operating Sequence - Electrolux EWF 1098 Instruction Booklet

Operating sequence

Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
of the detergent drawer. Then run a cotton
cycle at 60°C, with the machine empty, in order to
remove any manufacturing residue from the drum
and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.Place the laundry in the drum, one
item at a time, shaking them out as much as
possible.Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you wish to carry out the prewash or soak phase,
pour detergent into the appropriate compartment
marked .
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
.
15
4.Switch the machine ON and OFF
Turn the selector dial to the desired programme to the
switch appliance on.To switch the appliance off turn
it to "Off".
5.Select the desired programme
Turn the selector dial to the desired position: the LED
corresponding to the different phases making up the
selected programme illuminate.
The duration of the programme appears in the display.
6.Select the temperature
Press the "Temp." button if you wish to select a
temperature value different from the one proposed by
the washing machine. The relevant LED will light up.