JOUTEC Teye ADR3311 User Manual

Automated drive recorder

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Automated Drive Recorder

User Manual

Teye ADR3311

Table of Contents

Summary of Contents for JOUTEC Teye ADR3311

Page 1: User Manual
Automated Drive Recorder User Manual Teye ADR3311...
Page 2: Main Features
Main Features Unlike other in-car recording systems, the Drive Recorder is used to record both video and audio data in a conti nuous loop fashion. If the vehicle is involved in an accident such as a collision, impact, and sudden accelerati on-related incident, this data is marked and stored.
Page 3: Table Of Contents
Contents Before using the product Installati on sequence and method Cauti on prior to installati on Cauti on prior to storing Cauti on prior to cleaning Components Technical Speciﬁ cati ons SD Memory Card Speciﬁ cati ons Operati on Sequence Preparati on for video recording Conti nuous recording while driving Running the viewer program aft er driving...
Page 4: Before Using The Product
Before using the product Warranty and responsibiliti es ◆ Damage due to producti on malfuncti on, loss of data, or other damages occurring while using this product shall not be the responsibility of the manufacturer. ◆ Although the Drive Recorder is a device used for recording/storing videos, the device is not guaranteed to record informati on on every accident in the case of a malfuncti on.
Page 5 Cauti on! Do not remove the SD card during product operati on while power is on. Product or SD card could be damaged. Ejecti ng the SD card - Parking Surveillance mode is not set: Turn the car engine oﬀ . LCD will be turned oﬀ within 10 seconds.
Page 6: Installati On Sequence And Method
Installati on sequence and method Cauti on prior to installati on Stop the car at a safe parking lot before operati ng the device. Do not operate the product while driving. It might be a cause of car accident. Do not obstruct the view of the product through the front windshield. The GPS receiver may not work properly.
Page 7: Components
Components TV-OUT / IR cable Body & Cigarett e Lighter Plug Terminal Box External Alarm Butt on Remote Holder SD Card Manual Extra Camera Controller Product package may change for product enhancement without any noti ﬁ cati on. Technical Speciﬁ cati ons Built-in Camera 2 (1.3 Mega pixel CMOS sensor) Compression...
Page 8: Sd Memory Card Speciﬁ Cati Ons
SD Memory Card speciﬁ cati ons Recording ti me by frame rate & Video quality Maximum Recording Time (Min.) Time varies depending on the amount of moti on seen by the camera & lighti ng conditi ons. Cauti on! Do not remove SD card when the power is connected. (It might cause fatal damage to the SD card.) Do not use the card for any other purpose or copying unrelated ﬁ...
Page 9 SD Card Formatti ng Double click the downloaded files to install. Follow installation instructions. Select SD card drive. (SD card will be automatically recognized if SD card is inserted.) Click the [Option] and choose the “FORMAT SIZE ADJUSTMENT”. Check “ON” and click the OK button. Click the “FORMAT”...
Page 10: Operati On Sequence
Operati on sequence Preparati on for video recording Check to see whether the SD memory card has been inserted in to the device. and connect the power cable. If the device is connected to power, [HELLO] appears on the LCD display, indicati ng that the video recorder is initi alizing.
Page 11: Name Of The Parts
Name of the Parts Built-in Speaker SD card Slot Provides audio output for chime and any To insert the SD card into unit. informati on Display window Event release button/ Displays time and speed System power off button information. Release recorded data by event locks.
Page 12: Remote Controller
Extra Camera Interior Camera (Extra Camera) Records interior images of the vehicle. Holder Bracket For attaching the holder to the vehicle. Remote controller MOVE & MENU Button Move and select the desired menu function. (Activate TV-Out by pressing OK MENU key and select the menu.) Playback control button Playback the selected file and...
Page 13 After inserting the memory into USB port and powering it on, USB memory will be in priority to save the data. If SD card and USB memory are inserted at the same time, USB memory will work only for the recording. Please use the USB memories which are recommended by JOUTEC.
Page 14: Installing The Products
Installing the product Cauti on! Make sure to install with the igniti on turned oﬀ and car keys removed. Parti cularly, make sure to connect the power aft er installati on is complete. Recepti on will improve when the GPS receiver is fully exposed through the front window. Please keep clear the space to install the product in order to have enough viewpoint Without room mirrors or other att achment.
Page 15 Installati on of rear sensor The rear sensor cable is att ached with the rear camera and this cable can be connected with television, navigator, GPS monitor and small monitor to show the live view from rear side. (The rear sensor cable should be connected with rear lamp power terminal) Open the trunk(boot) Take a look at the rear of the vehicle and open...
Page 16: Lcd Display
LCD Display Name Descripti on Displays Time & Speed The sign is ON, while event recording (E butt on, G-Sensor detected) The sign is ON, while it is recording. The sign is ON, while front camera is recording. The sign is ON, while extra (rear) camera is recording. The sign is ON, while TV-out in process.
Page 17: Parking Surveillance
Parking Surveillance Noti ce Each vehicle has its own system and features. Please conduct this manual for the installati on as a reference. Please igniti on oﬀ while installing the parking surveillance. Please contact the car technician if needed. In order to use parking surveillance, cigar lighter power plug should be cut and use the cable for the wiring. Each part of T-BOX POWER SUPPLY VCC (+) POWER SUPPLY...
Page 18 Cauti on! Please place the T-Box in secure spot to be att ached. T-BOX Installati on Check the locati on of the fuse box in the vehicle. Fix the place to install the T-BOX in the vehicle. Adjust the length of the wire from T-BOX to the fuse box. Remove the A pillar like picture and insert (install)
Page 19 Aft er adjusti ng the cable, connect the power cable. Red wire is connected to “emergency butt on” fuse (the fuse with power aft er the igniti on is oﬀ ) black wire should be connected to the ground of vehicle. At the last, white wire which is igniti on wire is connected to cigarett e lighter power cable aft er the igniti on is of and check the status of cigarett e lighter power.
Page 20: Running The Program
Running the program PC system requirements Component Requirements Above Penti um4 / 1GHz processor or higher Menory 512MB of RAM or higher Microsoft Windows XP Home Editi on or higher Graphics DirectX 8.1b or higher HDD space 200MB or higher When using MS Windows Vista and T-eye Player soft ware for the ﬁ...
Page 21: To Review Video
To review video To playback video, select the “Open a File” butt on, explore the SD card or other locati on where the recorded (or saved) data is located, (ﬁ le called DATA is on the SD card), then double click the selected ﬁ le from the list in order to play. Name Descripti on Forward Camera View...
Page 22: Playback Interface Controls
Playback Interface Controls Butt on Functi on Butt on Functi on Move to the previous ﬁ le Move to the next ﬁ le Playback the previous frame Open a ﬁ le Pause the Playback Convert the ﬁ le into an AVI format Playback Link the recorded data with Stop map Playback Access System...
Page 23: Playback
Playback Aft er clicking the folder icon ( ) on the lower right corner of the viewer, click “Change Directory” to select the locati on for the recorded data. Typically the ﬁ rst ti me you do this all the ﬁ les are located on the data folder of SD card. If saved elsewhere, use this uti lity to explore your computer to locate the ﬁ...
Page 24: Converti Ng Into Avi Fi Le Format
Converti ng into AVI ﬁ le format Convert a porti on of the recorded data into an AVI ﬁ le format to playback on “Window media player” or to share the recorded data with someone else or email a ﬁ le. Click the AVI conversion butt on ( ) at the start of video clip positi on to convert the images into the AVI ﬁ...
Page 25: Interfacing With A Gis/City Map
Interfacing with a GIS/City map Drive Recorder simultaneously records the GPS data while driving so you can check the driver’s route on the map. Click the GIS/MAP icon ( ) on the lower right corner. The map window appears for the user to see the vehicle locati on and travel onto a city map. ※To use this functi on, the system must access the Internet.
Page 26: Pop-Up Display Window
Pop-up Display window With double-click the display window, the recorded images are played back at the original size. Double clicking the screen returns the view to normal, original size. Use the PC’s mouse to move the screens and adjust them within desktop window.
Page 27: System Conﬁ Gurati On
System conﬁ gurati on Click on the System Setup conﬁ gurati on icon ( ) located at the lower right corner of the Teye player. The following window will then appear. Name Descripti on Video Quality Frame rate setti ng Video Format Audio Recording Password Setti ng...
Page 28: Parking Surveillance Setti Ng
Parking surveillance Setti ng Name Descripti on Timer for parking Sets the parking surveillance ti me (none ~ 24h) Video Quality Sets the video recording quality. (5 Levels) Frame Rate Sets the video frame rate during the parking surveillance Audio Recording Enables or Disables the audio record functi on.
Page 29: Tv-Out Viewer
TV-OUT Viewer Name Descripti on Live Video Displays live video streaming Playback Playback video and audio data recorded System Conﬁ gurati on setti ngs Exit Closing TV-out...
Page 30: Live Video
Live Video 1. Displays live video streaming. 2. With the extra camera (the 2nd CH), PIP (picture in picture) functi on will be acti vated by [ ] butt on. MODE Playback recorded video data Down MODE Drive recorder must stop the recording during the playing recorded ﬁ les. System Setti ng For the setti ng detail, refert to the viewer program opti on.
Page 31: Analyzing G-Sensor Data
Analyzing G-SENSOR data The G-sensor (Gravity Sensor) furnishes data for X, Y and Z axis and stores it along with the other recorded data on the SD card. When using the playback soft ware, this informati on is represented in a graphic format. The resulti ng graph may be used to analysis the driving conditi on and driver’s habits.
Page 32: Soft Ware Update
Soft ware Update Remove the SD card from the device and insert to the SD card reader. Connect the SD card reader to PC through the USB port. Download the latest soft ware at the website and copy the update ﬁ les to the update folder of SD card. (Create “update”...
Page 33 MEMO...
Page 34 Ver 1.0...