Garmin STREET PILOT 7200 Owner's Manual page 58

A
PPENDIX
To slide the puck into the mounting base:
Locking
lever on the
mounting base
Sliding the Puck into the Base
1. Slide the puck on the bottom of the mounting
cradle into the mounting base.
2. Slide the base's locking lever to the right (locked).
3. Plug the power cable into a 12-Volt receptacle in
your vehicle.
4. Route the cable so it does not interfere with
vehicle operation.
50
To remove the puck from the mounting cradle:
1. Slide the cradle's locking lever to the left, swing
the cradle backward, and pull the cradle off of the
StreetPilot.
2. Remove the two screws from the front of the
cradle.
3. Remove the two screws, one on each side, near
the bottom of the cradle (see image below).
Locking lever
on the cradle
The puck mounting adapter is now detached from the
mount, allowing you to mount the StreetPilot 7200/7500
using a standard AMPS 4-hole mounting system.
Remove four screws
to remove the puck
and expose the 4-hole
pattern.
StreetPilot 7200/7500 Owner's Manual