Table of Contents
Advertisement
Operating Instructions
Starting a programme
0
1. Check that the dishes and cutlery are stacked in the dishwasher in such
a way that the spray arms are free to rotate.
2. Turn on the water tap fully.
3. Close the door.
4. Press the ON/OFF button.
The LED in the ON/OFF button will illuminate.
5. Press the relevant button for the programme required (see "Programme
Chart").
The programme display will become illuminated. The remaining time
for the programme will be shown in the multi-display.
The selected programme will begin after approximately 3 seconds.
During the programme, the remaining time shown in the multi-display
3
may be adjusted according to amount of dishes, degree of soiling, etc.
If an error message is displayed in the multi-display after the pro-
3
gramme has started, please read the section "What to do if ...".
Changing/interrupting/cancelling a programme
Only change or interrupt a programme that is in progress if it is abso-
3
lutely necessary. After the appliance has been closed again, the air that
has entered will be heated significantly and expand. As a result, water
may collect in the base of the appliance and trigger the anti-flood sys-
tem.
Changing a programme
If you would like to change the programme in the first 3 seconds after
3
having selected a programme, briefly press the button for the new pro-
gramme.
If you would like to change the programme after this time, proceed as
follows:
0
1. Press the button for the new programme and hold it down.
The indicator for the programme that is currently running will flash.
After several seconds only the indicator for the new programme will be
flashing.
2. Release the programme button.
The newly selected programme will begin.
28
Advertisement
Table of Contents
