Teac P-70 Owner's Manual page 19

CHECK
REPEAT
1, 2, 3...
Checking the programmed content
Use the CHECK button (repeated presses step through the
program) to check each track number, program number and the
total playback time in order. You can do this while playback is
taking place or is stopped.
< If the total playback time is over 100 minutes, the following
marks are displayed at ten's place of the "minutes" indication.
–: add 100 minutes to the displayed time.
P: add 110 minutes.
A: add 120 minutes.
b: add 130 minutes.
d: add 140 minutes.
no indication: add 150 minutes
In this example, the total playback time is 112 minutes and 30
seconds
How to add tracks to a program
You can add a track to the end of the program by using the
number buttons, either during playback or when playback is
stopped.
To add a track in the middle of the program, use the CHECK button
to step to the program step just before you want to insert the new
track, and then use the number buttons to enter the new track
number.
How to delete tracks from a program
PROGRAM
CLEAR
STOP (H)
Use the CLEAR button to clear the last program step entered into
a program, either during playback or when playback is stopped.
To delete program steps in the middle of a program, use the
CHECK button to display the program step to be deleted. Then
press the CLEAR button. The selected track is deleted from the
program and the track programmed next is moved to take its
place and shown on the display.
Clearing program mode
Clear program playback mode and the programmed order by
pressing the following buttons:
Clearing the program, but not the mode.
With the unit stopped, press the STOP button. Program playback
mode remains, but the programmed order is cleared.
Using Repeat Playback in programmed play
mode
Press the REPEAT button after setting the program order, and the
programmed tracks will be played back repeatedly.
PROGRAM, DELETE, SINGLE, OPEN/CLOSE, POWER
19