Go-Video DDV2001 User Manual page 27

Follow these steps to insert a new audio track, such as recorded
music or narration, onto your target tape. The new audio can be
recorded from the front audio input.
press
MENU
MAIN MENU
1 Copy Settings
2 Playback Settings
3 Record/Edit Settings
4 Channel Settings
5 VCR Settings
6 Timer Recording
7 Language/Langue
/ = Move = Sel
1
press
COPY SETTINGS
1 Comm. Free Copy
2 EZ Copy
3 Speed Matching
4 Copy Audio Insert
/ = Move = Sel
press
for Copy Audio Insert
4
N O T E S
• If you wish to use a microphone to insert the new audio track, it must be connected to a preamp.
• Do not connect speaker outputs to the VCR.
• If there is no audio signal, the audio track will be blank.
• Copy Audio Insert automatically reverts to "Off" when the VCR is turned off.
1
2
3
MENU = Quit
4
On
Off
On
Off
5
MENU = Quit
6
O P E N M A I N M E N U
Press MENU.
S E L E C T " C O P Y S E T T I N G S "
Press 1.
S E T C O P Y A U D I O I N S E R T
Press 4 to choose from the following:
O f f
Copy Audio Insert is disabled. The existing
audio will be copied.
A u x
While copying, a new linear (mono) audio
track will be recorded from an external
audio source connected to the front audio
jack.
C O N N E C T A U D I O S O U R C E
Connect your external audio source to the
front audio input using standard RCA audio
cables; see notes below.
C U E T A P E S
Cue up all devices:
• Source tape in Deck 1.
• Target tape in Deck 2.
• The external audio source (tape player,
CD player, etc.) connected to the front
audio input.
C O P Y N E W A U D I O T R A C K
Press COPY TAPE on the VCR, and press
PLAY on your external audio source at the
same time.
• The new audio signal will be copied in
place of the original audio track.
21
7 - Edit