Registering (Pairing) And Connecting With The Cell Phone - Blaupunkt BT HS 112 Operating And Installation Manual

Registering (pairing) and connecting with the cell phone

Before you can use the BT HS 112, you must register and connect it with
a Bluetooth-ready cell phone. Registering is a one-time process and required
only for the fi rst connection with the cell phone. The BT HS 112 can be reg-
istered with up to eight cell phones and be connected simultaneously with
two cell phones.
– Hold the BT HS 112 within range of a Bluetooth-ready cell phone; the
distance should not exceed a metre.
– The BT HS 112 must be switched off .
– Press the MF button for approx. 5 seconds until you hear a low-pitched
signal tone and the LED display intermittently fl ashes red and blue. The
headset is in registration mode.
– Activate the Bluetooth function of the cell phone and start the search for
Bluetooth devices. (For further details, please read the operating instruc-
tions of your cell phone.)
– From the list of devices found, select "BT HS 112".
– If required, enter the PIN code "0000" and confi rm the entry. If the pair-
ing process was successful, you hear a signal tone and the LED display
fl ashes blue 3 times. (Note: The PIN code is preprogrammed and cannot
be changed. If the cell phone supports the Secure Simple Pairing (SSP)
function, you do not have to enter a PIN code for the pairing.)
– After registering, the BT HS 112 automatically connects with the cell phone.
For some cell phones, you have to manually confi rm the connection. Next,
the BT HS 112 changes to standby mode and the LED display fl ashes blue
every 3 seconds.
Note: If the registering is not completed within 2 minutes, the BT HS 112
switches off again. In this case, repeat the registering.
8