Table of Contents
Advertisement
Resetting the BT HS 112
The BT HS 112 can be registered with up to eight cell phones. You can delete
the list of registered phones and reset the headset to the factory settings.
– The BT HS 112 must be switched on and no connection may exist to
a cell phone.
– Press and hold down the "+" and "–" volume buttons simultaneously for
approx. 10 seconds until the LED display intermittently fl ashes lights red
and blue.
– After the factory settings have been restored, the LED display stops fl ash-
ing intermittently.
– After the next switch-on, the BT HS 112 is in registration mode.
LED displays and signal tones
Device status
Switching on
Switching off
Registration mode
Standby mode
without connection
Standby mode
with connection
Incoming call
Active call
Mute
Low battery
Battery is charging
12
LED displays
Lights blue for 3 seconds
Lights red for 3 seconds
Flashes red and blue alternately
Flashes blue once every 3 seconds
Lights blue every 3 seconds
Flashes blue
Flashes blue once every 2 seconds
Flashes red once every 10 seconds 2 tones every
Flashes red once every 3 seconds
Lights red.
Lights blue after the battery is
fully charged.
Signal tones
1 high-pitched
sound
1 low-pitched
sound
10 seconds
5 tones every
20 seconds
Advertisement
Table of Contents
