Reg - Regional; Selecting A Station; Automatic Seek Tuning; Manual Seek Tuning - Blaupunkt MADEIRA RCR 85 Operating Instructions Manual

"SEARCH" goes out as soon as the system
has found an alternative frequency or after
the frequency band has been scanned com-
pletely.
Should the reception quality of the selected
program become too bad,
• tune into another program.

REG - Regional

The AF function can also be used to activate
and deactivate the regional function. At some
time of the day, larger radio stations split up
their main program into regional program
versions offering local information.
If you want the radio to lock onto a regional
program,
• hold down the AF button for about 2
seconds.
The display will show "REG ON".
If you leave the service area of the regional
program or if you wish to use the entire RDS
service, switch to "REG OFF".
• Hold down the AF button for about 2
seconds until "REG OFF" is displayed.
If "REG ON" is activated, the display will
show "REG ON" each time the radio is
switched on.
22

Selecting a station

This set allows you to receive FM stations
between 87.5 and 108 MHz.

Automatic seek tuning

• Press / . The radio will automatically
tune into the following station.
If you keep the upper or lower part of the
rocker switch / depressed, seek tuning
speeds up in upwards or downwards direc-
tion.
Seek tuning
up
down in
short steps
down
Manual seek tuning << >>
• Press << or >> to change the frequency
in small steps in upwards/downwards
direction.
Hold down the right or left part of the rocker
switch to speed up this procedure.
Adjusting the seek tuning sensi-
tivity
The set allows you to modify the seek tuning
sensitivity.
/ If "lo" lights up, the radio will only pick up
strong stations (low sensitivity).
If "dx" lights up, the radio will also pick up less
powerful stations (higher sensitivity).
To change the seek tuning sensitivity,
• press lo.
On top of this, the sensitivity levels can be
adjusted separately for lo and dx (see chap-
ter "DSC programming").

Stereo - mono switch (FM)

You can switch to mono when the reception
up in
quality becomes poor:
short steps
• Press lo for approximately 2 seconds.
During mono reception the stereo sym-
bol
Each time the car radio is switched on, the
radio will be automatically set to stereo recep-
tion.
It will automatically shift to mono when the
reception quality becomes poor.
on the display will go out.