Advertisement
Advertisement
Related Manuals for Electrolux EFC 928
Summary of Contents for Electrolux EFC 928
- Page 1 User Manual EFC 928...
-
Page 2: Table Of Contents
Contents Safety instructions ..............2 Description of the cooker hood ..........3 Using the cooker hood ............3 Maintenance and cleaning ........... 4 If the hood does not function ..........5 Technical data ..............5 Installation ................5 Safety instructions The cooker hood may only be used in a private household and for normal cooking purposes. -
Page 3: Description Of The Cooker Hood
Description of the cooker hood The cooker hood 1 Control panel 2 Grease filter 3 Lamp 4 Chimney Fig. 1 Accessories The following are included with the cooker hood (Fig. 1): • Screws for mounting • Template • Non return fume valve (mounted in the outlet hole) Functions There are two possible systems: •... -
Page 4: Using The Cooker Hood
Using the cooker hood The control panel Best results are obtained by using low speed for normal conditions and high speed when smells and steam are more concentrated. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all steam and smells have disappeared. -
Page 5: Maintenance And Cleaning
Maintenance and cleaning Before doing any maintenance work on the hood, Clean the filter regularly. The grease that disconnect it from the main supply by collects in the filter and the duct could ignite disconnecting the plug from the wall socket or if a hot plate is left on (or if overheating unscrewing the fuse. -
Page 6: If The Hood Does Not Function
Your dealer or service company will supply you with service and spare parts. Be sure you have the product number and model name at hand when ordering service or parts. Technical data Model EFC 928 X Size Height 800-1340 mm Width... - Page 7 Mounting the cooker hood - Fig. 5 • Rest the template correctly against the wall. The lower corner of the template corresponds to the lower corner of the extractor hood. Fig. 3. • A cross is marked on the template to indicate the centre. Mark this point on the wall.
- Page 8 • Remove the telescopic chimney support M by unscrewing the side screws R (one on each side - these screws must be kept). Fig. 6. • Remove the air pipe L from the telescopic chimney support M; to do this, unscrew the four screws (Ø 2,9 x 9,5 mm) fixing the air pipe to the support (these screws must be kept).
- Page 12 LI1REA Ed.06/01...