26 electrolux what to do if...
Malfunction
The machine fills then
empties immediately:
The machine does not
empty and/or does not
spin:
There is water on the
floor:
Unsatisfactory washing
results:
Possible cause
The end of the drain
●
hose is too low.
The drain hose is
●
squashed or kinked. E20
The drain pump is
●
clogged. E20
The Rinse Hold option
has been selected.
The laundry is not evenly
●
distributed in the drum.
Too much detergent or
●
unsuitable detergent
(creates too much foam)
has been used.
Check whether there are
●
any leaks from one of the
inlet hose fittings. It is not
always easy to see this
as the water runs down
the hose; check to see if
it is damp.
The drain hose is
●
damaged.
The cap on the
●
emergency emptying
hose has not been
replaced after cleaning
the pump.
Too little detergent or
●
unsuitable detergent has
been used.
Stubborn stains have not
●
been treated prior to
washing.
The correct temperature
●
was not selected.
Excessive laundry load.
●
Solution
Refer to relevant
●
paragraph in "water
drainage" section.
Check the drain hose
●
connection.
Clean the drain pump.
●
Select the Drain or Spin
●
programme.
Redistribute the laundry.
●
Reduce the detergent
●
quantity or use another
one.
Check the water inlet
●
hose connection.
Change it with a new
●
one.
Put the cap back on the
●
emergency emptying and
place the latter back in its
seat.
Increase the detergent
●
quantity or use another
one.
Use commercial products
●
to treat the stubborn
stains.
Check if you have
●
selected the correct
temperature.
Introduce into the drum
●
less laundry.