Wide Screen Operation With Computer Signals - NEC PlasmaSync 61XM3 Model Information

Wide Screen Operation with
Computer Signals
Switch to the wide screen mode to expand the 4 : 3 image
to fill the entire screen.
1. Press the WIDE button on the remote control.
2. Within 3 seconds ...
Press the WIDE button again.
The screen size switches as follows:
NORMAL FULL ZOOM
When displaying enhanced split screen:
NORMAL FULL
NORMAL size screen (4:3 or SXGA 5:4)
The picture has the same size as the normal computer image.
FULL size screen
The image is expanded in the horizontal direction.
ZOOM size screen
When wide signals are input.
FULL size screen
When "PICTURE SIZE" is set to "OFF"
The screen size switches as follows:
TRUE FULL ZOOM
TRUE size screen (VGA, SVGA 4:3)
The image is true resolution.
FULL size screen
The image is expanded in the horizontal and vertical
direction.
ZOOM size screen
When wide signals are input.
TRUE
The image is true resolution.
FULL
Information
Supported resolution
See page E-2 of Model Information for details on the
display output of the various VESA signal standards
supported by the monitor.
"PICTURE SIZE" setting
When the setting of "PICTURE SIZE" is OFF, the size
of RGB-input pictures will be TRUE in place of
NORMAL.
When 852 (848) dot
signals with a vertical frequency of 60 Hz and
horizontal frequency of 31.7 (31.0) kHz are in-
put
Select an appropriate setting for RGB SELECT mode
referring to the"Table of Signals Supported" on page
E-2 of Model Information.
* "VGA", "SVGA" and "SXGA" are registered
trademarks of IBM, Inc. of the United States.
Note:
Do not allow the displayed in 4:3 mode for an extended
period. This can cause a phosphor burn-in.
E-12
4-16
CONFIDENTIAL
480 line wide VGA*