AEG FAVORIT 86470 I User Information page 24

Operating instructions
Malfunction
The indicator for the
selected programme is
flashing; fault code
is displayed in the
multi-display. (Problems
with water outflow)
Fault code
displayed in the multi-
display.
The SIEB control
indicator is lit.
The DOOR (TÜR)
indicator is lit.
The programme is not
starting.
Rust spots are visible in
washing compartment.
There is a whistling
noise during washing.
24
Possible cause
The siphon is blocked.
The water drain hose
has not been correctly
laid.
is
The leak prevention system
has been triggered.
The indicator SIEB is only
intended to remind you to
occasionally check the
dishwasher's filter and to
clean it out when necessary.
It becomes illuminated at
regular intervals, regardless
of the state of cleanliness of
the filter.
The door of the dishwasher
is not closed properly.
Mains plug is not plugged in.
House fuse in defective.
In the case of dishwasher
models with start delay
timer:
A start delay is selected.
Rust spots in the washing
compartment are from
particles from outside the
appliance (rust particles
from the water pipe, from
pans, cutlery, etc). Remove
such spots with a
commercially available
stainless steel cleaner.
The whistling is not a cause
for concern.
Remedy
Clean out siphon.
Check hose installation.
Turn off the tap and contact
customer service.
Turn off the tap and contact
your local Service Force
Centre.
Shut the door.
Insert mains plug.
Replace fuse.
If dishes are to be washed
immediately cancel delay
start timer.
Only wash cutlery and dishes
that are suitable for dish-
washer use.
Close the lid of the special
salt container securely.
Use a different brand of
detergent.