Gas Connections - AEG Electrolux 75580G-M Instruction Booklet

IMPORTANT
This hob must be installed by a competent person to the relevant Gas Standards.
Any gas installation must be carried out by a registered competent person.
Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the
event of a breakdown.
The manufacturer will not accept
liability, should
instructions or any of the other
safety instructions incorporated in
this instruction booklet be ignored.
On the end of the shaft, which includes
the G 1/2" threaded elbow, adjustment
is fixed so that the washer is fitted
between the components as shown in
the diagram. Screw the parts together
without using excessive force.
Gas Connection
Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or
copper.
The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread).
When the final connection has been made, it is essential that a thorough leak test is
carried out on the hob and installation.
Ensure that the main connection pipe does not exert any strain on the hob.
It is important to install the elbow correctly, with the shoulder on the end of the
thread, fitted to the hob connecting pipe.
Failure to ensure the correct assembly will cause leakage of gas.
WARNING
Check to be sure that all connections to the unit are completely gas-tight; use a soap
solution to do this, never a flame.
the above
A) End of shaft with nut
B) Washer
C) Elbow
15