AEG Electrolux 78031KF-MN User Manual page 15

Problem/Display
Display is switching between
two heat settings
The residual heat indicator is
not displaying anything
lights up
lights up
and number are displayed
Acoustic signal sounds when
appliance is switched off
Repeated acoustic signal (6x),
appliance switches off
Acoustic signal sounds and ap-
pliance switches itself on and
then off again; after 5 seconds
another acoustic signal sounds
If you are unable to remedy the problem by following the above suggestions, please
contact your local Service Force Centre.
WARNING!
Repairs to the appliance are only to be carried out by qualified service engineers. Consid-
erable danger to the user may result from improper repairs.
Possible Cause
Automatic switch-off has been
triggered
There is water on the control
panel or the control panel is
covered with fat splashes
STOP+GO is activated
Power management is reduc-
ing the power of this cooking
zone
The cooking zone was only on
for a short time and is therefore
not hot
Unsuitable cookware
No cookware on the cooking
zone
Diameter of the base of the
cookware is too small for the
cooking zone
Automatic switch-off has been
triggered
Electronics fault
The control panel is wholly or
partly covered by objects.
One or more sensor fields have
been covered for longer than
10 seconds
The On/Off sensor field has
been covered up, e.g. by a cloth
What to do if ...
Remedy
Remove any objects (pans, etc.)
that are lying on the control
panel. Switch appliance on
again
Wipe the control panel
Switch off STOP+GO
See the section "Switching the
power function on and off"
If the cooking zone is supposed
to be hot, call your local Service
Force Centre.
Use suitable cookware
Put cookware on zone
Move to smaller cooking zone
Use suitable cookware
Switch appliance off. Switch
appliance on again
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's wiring system) If
after switching on again,
displayed again, call the cus-
tomer service department
Remove objects.
Uncover sensor field
Do not place any objects on the
control panel
15
is