Table of Contents
Advertisement
Instructions for the installer
The following instructions about
installation and maintenance must
be carried out by qualified personnel
in compliance with the regulation in
force. The regulation to be applied
for this type of installation is NBN D
5I.003 : "Installations functioning with
combustible gas lighter than air".
The side walls of the unit in which the
hob is going to be installed, must not
exceed the height of the working top.
Avoid installing the appliance in the
proximity of inflammable materials
(e.g. curtains, tea towels etc.).
The appliance must be electrically
disconnected before all interventions.
If any electric supply to the appliance
is required to carry out the work,
ensure all the necessary precautions
are followed.
Gas connection
It is indispensible that the connection to the
gas mains are carried out by means of an
AGB tap. Choose fixed connections or use
a flexible pipe in AGB (stainless steel).
If using flexible metallic pipes, be careful
they do not come in contact with mobile
parts or they are not squeezed. Use the
same attention when the hob is combinated
with an oven.
This hob can be operated by Slochteren gas
(G25) with a nominal pressure of 25 mbar or
by natural gas with nominal pressure of 20
mbar. No regulation is required for use by
these two types of gas. Before fitting the
appliance ensure that the installation has
the correct voltage for the appliance. At full
capacity, the drop in pressure must not
exceed 5%. Such a drop in pressure is
caused by the following parameters:
-
maximum capacity of meter;
2 6
Advertisement
Table of Contents
