Table of Contents
Advertisement
Description of the appliance
2
1
Instruction for the User
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a pan on
the pan support.
To light a burner, turn the relevant knob anticlockwise to
maximum position and push down the knob to ignite.
After lighting the flame, keep the knob pushed down for about
5 seconds. This will allow the "thermocouple" (Fig. 1 lett. D) to
be heated and the safety device to be switched off, otherwise
the gas supply would be interrupted. Then, check the flame is
regular and adjust it as required.
If you cannot light the flame even after several attempts, check the "cap" (Fig. 1 lett. A) is in the correct
position. To put the flame out, turn the knob to the symbol .
•
Always turn the flame down or put it out before taking the pans off the burner.
Each control knob is equipped with a pilot light which gradually lights up according
to the heatlevel that you select with the control knob.
2
4
2
1. Hob top
3
2. Semi-rapid burner
3. Auxiliary burner
4. Ultra-rapid triple crown burner
5. Control knobs
5
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple
Fig. 1
45
Advertisement
Table of Contents
